Help needed in drawing subatomic particle spirals

[Acorn]

I've tried using the Shape Tool with Curve and Smooth join set.
I set two initial point, then a third 90 degrees and half the length.
The fourth 90 degrees again and half the length of the third.
Repeat until bored.

You then have to adjust the curve slightly between the first and second points and the last two.

You can vary the ratio of adjacent lines.

You can throw in a Mould Envelope to get a perspective.

Acorn

[Egg Bramhill]

Here's my atempt. I used Inkscape to create the spirals, only two of them, cut & copied into Xara. The copy on the right is a 85% jpg, the one on the left a 40% jpg which gives it a rougher texture.
The spirals where to accurate & required pulling about a bit.

[WildRice]

Those look great, thanks everyone!