The way I've been doing it is to draw two circles, align them centrally, then Combine Shapes >> Subtract. This leaves you with a circle with a hole in the middle.
Then use the 3D tool to extrude it as required.
Member
Re: How do I draw a torus with a cutout on the inside?
The way I've been doing it is to draw two circles, align them centrally, then Combine Shapes >> Subtract. This leaves you with a circle with a hole in the middle.
Then use the 3D tool to extrude it as required.
Last edited by DOAADI; 20 October 2012 at 05:18 PM. Reason: Add image
Posting Permissions
Reply With Quote
Bookmarks