Re: Inverted Rounded Corner Rectangles (Incut Rectangles)
Originally Posted by
Albacore
I know it is not so accurate but why did no one state the obvious. After doing the Ctrl+Shift+S and if you have your constraint angle set at 45 then Ctrl+drag the nodes around saves a lot of time.
...because
- In the solution I gave to the OP there was no need for Ctrl+Shift+S
- I did specifically mention Ctrl+Drag
Just read up a few posts until you see my diagram.
If someone tried to make me dig my own grave I would say No.
They're going to kill me anyway and I'd love to die the way I lived:
Avoiding Manual Labour.
Member
Posting Permissions
Reply With Quote
Bookmarks