http://www.xaraxone.com/webxealot/workbook51/page_1.htm
I thought this short and easy tutorial would take but a minute to do. Wrong. I ran into a problem with it.
I do fine until I get down to the wavy line I'm going to use to slice my lamp base. I made a wavy line with the freehand tool and set the line width to 16. I then sliced as instructed and it did slice the objects. I don't get a separate wavy object in the center of the lamp base to apply a fill to.
So, I go back and read it again. It says 'Change the outline Width to 16pt'. What is 'outline width' and how is that different from line width? I can only assume they are different as line width did not work for me.
Bookmarks