logo warps/deforms/xara3d

[magbobote]

good morning to all..
i imported a logo wmf format put a texture on it.everything was going well except when i put an animation (rotate). the logo warps or deforms as soon as starts spinning. texture is in jpg format.
any help would be highly appreciated..
thanks and more power...

[simsmj]

Could you post an image of what is happening, or post the x3d file? That would help diagnose the problem.

Mike

[magbobote]

Could you post an image of what is happening, or post the x3d file? That would help diagnose the problem.

Mike

thanks this will be my first time to send/attach an image. dunno if it will go through i usually have a bad internet access at the cafe..

[Egg Bramhill]

magbobote,

I can't see any warp/deformation.

This is what I get.

[ankhor]

magbobote,

I can't see any warp/deformation.

This is what I get.

If you spin it around I see a deformation at the point
where the incuts are, probably because the texture want to
also go inside the incuts.

Made an avi out of it and the deformations don`t show.
I`ll see what a gif does.
yep the gif also doesn`t show the deformation.
It only happens in the program itself.

[magbobote]

thanks and many thanks.
i did not actually view the image in other format, except in xara3d. you're right guys, no deformation in avi and gif format. why didn't i try that? ...
anyway thanks for the very quick response. more power.

[suunto]

i experienced this, i was following some of the threads and it was going as intructed but then the image seemed to concave in, whilst rotating
but once exported it was fine