Re: TIME FOR A BREAK
The mug's OK however it’s too bad you didn't mold the text to fit the shape of the mug. If you still have your Xara file you still can, and, I think you will have a much better result. Look at the discussion link below and on Xara Xone for more information.
Below is a link to show what I’m talking about. 3rd post down #33 posted by Gare.
http://www.talkgraphics.com/showthre...-a-Shape/page4
This was a very good discussion and Gare also submitted a blank soda can for us to fit a label to.
Larry a.k.a wizard509
Never give up. You will never fail, but you may find a lot of ways that don't work.
Bookmarks