As a matter of interest only:
Although Fred's method creates a 'circle' it is not an exact circle. The shape is very circular but not a true circle. But then again neither is a circle created by the ellipse tool. To test this out zoom to 10%, create the largest circle you can which is still totally visible. I created on one 7000 x 7000 px. Now rotate it 22.5 degrees, it becomes 6997.9 x 6997.9, two pixels smaller, how can this be, shock, horror
Can anyone confirm my video is streaming. I can see it but several hours later Acorn cannot.
Egg
Minis Forum UM780XTX AMD Ryzen7 7840HS with AMD Radeon 780M Graphics + 32 GB Ram + MSI Optix Mag321 Curv monitor + 1Tb SSD + 232 GB SSD + 250 GB SSD portable drive + ISP = BT + Web Hosting = TSO Host
Yes, video works fine here Egg.
Note: Fred & I's method works fine here and produces a 100% perfect circle.
But remember to use 'Radius' or 'Diameter' creation. NOT bounds.
This is the point I noted out of pure interest Steve, it doesn't create a perfect circle. Create a circle with the ellipse tool. size it to 300x300px. Create the circle via your quick shape tool method. set it to 300 x 300px. Select both and align together centrally. Zoom into top left side in wireframe, there is a gap. Not at the top, bottom, left or right sides but at the intermeadiate points nw, ne, se & sw.
So it creates a circle that for all intended use is a near enough circle, but not the perfect circle
Egg
Minis Forum UM780XTX AMD Ryzen7 7840HS with AMD Radeon 780M Graphics + 32 GB Ram + MSI Optix Mag321 Curv monitor + 1Tb SSD + 232 GB SSD + 250 GB SSD portable drive + ISP = BT + Web Hosting = TSO Host
Bookmarks