Muppet question for a webby

[Albacore]

The only other comments I would make is that going from RGB to CMYK through the PDF export filter is going a lot of the colours a slightly washed out look. The best thing to do after looking at your file in Acro reader is to import it back into Xara and adjust the colours again, through the CMYK colour profile, then export it again. If the printer is using A3 format I would make a template using layers. Bring up the Rulers Shift+Ctrl+R and drag a vertical line out but not on the paper. With the Guide layer selected, select the rectangle tool M and then make a rectangle 14.85cm x 21.0cm on a landscape A3 page. Now we run into problem if the page has full bleed as we can only fit two A5 sheets on the page as 4 fits it exactly and you would never print borderless even if the printer could do it as it causes problems for the drum or rollers on the printer. If the large format printer can take A3+ or SAR3 then we can position 4 A5 guide rectangle on the page by dragging and using Ctrl+right hand mouse click to place a duplicate on the page. You use the same method again after selecting both rectangles to dulpicate the 3 & 4 rectangle by dragging down the page & clicking.
Make a new layer and if you want call it crop marks then on your first lefthand rectangle draw corner crop marks, around 4 to 8 mm long + group them. Do the same to all corners of this top left hand guide rectangle. It is always easier to lock the guides when doing this. Now group all of the drawn cropmarks and Use Ctrl+drag+right hand click using the mouse to duplicate and cover the top right hand guide rectangle. Group both sets of rectangle crop marks and use the same method to cover both bottom guide rectangles.

That is now your bleed guides drawn so that you can have full colour. Draw your design over the guides making each side overhang the guide rectangle by at least 3 mm. Have a look at the supplied template and if you have any questions please come back.