Hello jnerf,

I saved out as a PNG using several resolutions with your file as is. No problem here as regards crashing. The bevel wasn't produced on the entire bevel, though. No idea why other than perhaps we can add that to a fix-it list.

Instead of using the original size (because the bevel was not produced properly across the entire 14000+ length), I reduced the size of the graphic to 1/3 the length and exported at 300 ppi. This produces a file of roughly equal length--and did so properly. It should place fine in Artrage and sizing it a bit will not / should not hurt the print. I use to do this in PhotoShop all the time for signage. I have not used Artrage, though.

I uploaded the PNG and you are welcome to it. I'll leave it up for a day or two. It is a 2 meg+ PNG file. I would right-click and save it rather than view it.

http://www.wenzloffandsons.com/temp/splasho.png

Take care, Mike