Could someone make this image 3D and spin please?!

**mindela** · 08 August 2006, 03:30 PM

Is there a way to have some words circling a main logo? I want 4 words to circle around the letters BP3.

Also The 3 in BP3 is littler than the BP and I have figured out how to do that, but can I make the 3 a different font than the BP and the same for the words circling...can I make them a different font than the BP?

Thank you for your help.

**crowej** · 15 September 2006, 11:23 AM

could you please make this spin ? thanks

**parahandy** · 15 September 2006, 01:58 PM

Like this? a bit large file

**legodcantona** · 15 September 2006, 07:52 PM

Hi, could someone please make this image spin please?

Kindest regards, Matt (legodcantona@hotmail.com)

http://p6.piczo.com/img/i114825115_54778_6.gif

**-=Drifter=-** · 15 September 2006, 07:59 PM

This is regarding post #7 of this thread by Egg: Egg, how did you make just part of the flag's surface stick out like that?

**simsmj** · 15 September 2006, 08:12 PM

Drifter, Egg's flag is made of three separate shapes superimposed on each other, and each with different extrusions, but all given the same animation parameters so that they spin together.

Mike

**parahandy** · 15 September 2006, 08:15 PM

Originally Posted by legodcantona

Hi, could someone please make this image spin please?

Kindest regards, Matt (legodcantona@hotmail.com)

http://p6.piczo.com/img/i114825115_54778_6.gif

What Image? just a redcross I'm afraid

**Hwy101** · 17 September 2006, 11:57 PM

Man! You guys are GOOD! Tom

**simsmj** · 18 September 2006, 06:26 AM

Xara3D can only appy an extrusion to the whole of a given shape. If you want different parts to have different extrusions, then these parts must be separately imported shapes.

But there is a wrinkle with X3D regarding what it sees as separate shapes.

If you select two separate ungrouped shapes in XaraXtreme and then paste them simultaneously into Xara3D, X3D will take the two shapes as a single entity. If you paste them separately, ie. one at a time, then X3D will see them as separate shapes. Egg's flag above consists of three separate shapes, one white, one red, one blue, and each has a different colour and extrusion.

Mike

**-=Drifter=-** · 18 September 2006, 03:45 PM

I still cannot figure out how to add one little piece to 3D. I have been playing with the flag Egg drew. I managed to get the red sections to stand out. Now (and certainly not to defile the wonderful flag) I have been trying to add just one little red square in the middle - extruded - just like with the stalybridge logo pic. Can't seem to do that. I did manage to get the red square into 3D larger than it was in Xtreme, and then changing the font size to 20 made it the correct size, but then line spacing would not allow me to move it all the way up to where it should be.