Well, mine started with cloning the line and flipping it horizontally to make the outline of the dog's mouth. The rest was built off of that.
Well, mine started with cloning the line and flipping it horizontally to make the outline of the dog's mouth. The rest was built off of that.
R_o_n _a_l _d __C. __D_u_k_e
x a r a . c o m..a r t i s t s ..g a l l e r y
Xara's Facebook
Xara Designer Pro X 16, Xara 3D7 Web Designer
Thanks Ron,very good
Larry a.k.a wizard509
Never give up. You will never fail, but you may find a lot of ways that don't work.
Frightening dog there Ron! Great drawing.
Egg
Minis Forum UM780XTX AMD Ryzen7 7840HS with AMD Radeon 780M Graphics + 32 GB Ram + MSI Optix Mag321 Curv monitor + 1Tb SSD + 232 GB SSD + 250 GB SSD portable drive + ISP = BT + Web Hosting = TSO Host
DittoNot sure I could live with it on my wall though!
Egg
Minis Forum UM780XTX AMD Ryzen7 7840HS with AMD Radeon 780M Graphics + 32 GB Ram + MSI Optix Mag321 Curv monitor + 1Tb SSD + 232 GB SSD + 250 GB SSD portable drive + ISP = BT + Web Hosting = TSO Host
Larry a.k.a wizard509
Never give up. You will never fail, but you may find a lot of ways that don't work.
Featured Artist on Xara Xone . May 2011
. A Shield . My First Tutorial
. Bottle Cap . My Second Tutorial on Xara Xone
The only place I could fit the scribble is in the Bandana.
But, it works, I think!
Featured Artist on Xara Xone . May 2011
. A Shield . My First Tutorial
. Bottle Cap . My Second Tutorial on Xara Xone
A last minute scribble with a early Santa Claus.
Bookmarks