Transparent sides of Text (see-through material) in Xara3D ?

[wizard509]

What I did was Clone the text, One layer of text extruded with no transparency.
Another layer transparent no extrude.
This is where the fiddly part came in.
I had to move, line up both as best I could and change the size of the non transparent text so it fit over the transparent extruded text.
I wonder what would happen if both texts were selected and rotated with the 3D tool to see more of the top. Guess I'll try and find out.
The multicolored rectangle was only there so you could see what was transparent and what was not. I kept trying to line up both texts and I thought I had it but when I looked at the png it was off.

[wizard509]

Just finished another version of the transparent sides I think this one looks bitter.

Used XPGD365

transparent sides 2.xar

[iamtheblues]

I used XP&GD with the blend tool to create the 3D and then applied a linear transparency.
Bob.

[winssol]

nice thank you every one