Re: New Printer, Only prints half of whats on the page?
just so im clear its XARA not the printer? correct???
No I don't think so. Firstly you need to set up your page size in Xara. It's not a standard page size, so you'll need to set up a custom page size.
Then you need to set up the Printer Properties. I only have an A4 printer so it won't allow me to enter 20" x 10" but yours obviously will. You'll probably need to mess with the page bleed sizes too.
If you're going to be doing this a lot save your xar file:
Save Template /20x10 (or whatever name suits). You won't need to go through these steps each time then (I thinks )
Egg
Minis Forum UM780XTX AMD Ryzen7 7840HS with AMD Radeon 780M Graphics + 32 GB Ram + MSI Optix Mag321 Curv monitor + 1Tb SSD + 232 GB SSD + 250 GB SSD portable drive + ISP = BT + Web Hosting = TSO Host
Bookmarks