Scaled Printing

**DanFelix** · 12 February 2016, 01:03 AM

A long time ago I was able to take a one page document and print it on four pages, essentially scaling it 2x in both directions. I have completely forgotten how I did that and I can't seem to find the configuration in DP11 to do that again. A little memory assistance would be appreciated. Thanks.

Dan

**gwpriester** · 12 February 2016, 01:10 AM

Well there is not automatic way to do this. But here is how I would do it. Divide the image into four parts and put each part on a separate page. Print all four pages then assemble the four parts into a single image.

**Egg Bramhill** · 12 February 2016, 01:58 AM

Many moons ago CC Artworks could do this easily but I don't believe it was ever carried across to Xara software.

**mwenz** · 12 February 2016, 01:58 AM

One can design at the desired size, export to PDF and use Adobe Reader or most all other PDF readers to print a tiled version. Usually one would also use overlap and include the marks to make aligning easier.

Mike