Just to let you all know I am working on my glyphs, but I'll be a day or two before I get them posted.
Just to let you all know I am working on my glyphs, but I'll be a day or two before I get them posted.
[SIGPIC][/SIGPIC]
My current Xara software: Designer Pro 365 12.6
Good Morning Sunshine.ca | Good Morning Sunshine Online(a weekly humorous publication created with XDP and exported as a web document) | Angelize Online resource shop | My Video Tutorials | My DropBox |
Autocorrect: It can be your worst enema.
Fred the red letters in the template are only suggestions as I stated in the thread that contains the template.
Larry the square brackets should be the same have the same stem width as a capital letter and the same height. In the template file you will find a right hand parenthises as an example.
The attached .zip file contains a png of Gary's original image of the Roundhead sample sheet page. I have used an application that uses an s-spline algorithm to enlarge the image and sharpen the outlines. I hope this may help everyone.
Soquili
a.k.a. Bill Taylor
Bill is no longer with us. He died on 10 Dec 2012. We remember him always.
My TG Album
Last XaReg update
Thanks Bill, I did note the example parenthesis example. It looks like it was on the base line and in my mind at least they should be somewhat longer then the capital height and descender, and centered which makes them not fit the template. So please someone tell me I'm wrong. I hope I'm making sense.
Larry a.k.a wizard509
Never give up. You will never fail, but you may find a lot of ways that don't work.
Bill here are the glyphs that I have been fixing. I hope these measure up!
Michele
__________________________
www.michelemowat.com
OK here is the punctuation. I hope it is OK. If there is anything I missed let me know.
RoundHead punctuation.xar
Larry a.k.a wizard509
Never give up. You will never fail, but you may find a lot of ways that don't work.
To complete this project we still need the upper and lower case glyphs to conform to the template. Anyone up to the job?
Soquili
a.k.a. Bill Taylor
Bill is no longer with us. He died on 10 Dec 2012. We remember him always.
My TG Album
Last XaReg update
@Bill—
I think we'd all like some closure on this font, so we can use the bloody thing instead of trying to build it!
Send what you have to me via PM, and I will dedicate this afternoon to completing the rework so the characters have consistent stems and heights and ya-da-dah.
My Best,
Gary
Thanks Gary. Do you want the old upper and lower case files that have not been updated to comply with the template or just the files that Michele and Larry have updated?
Soquili
a.k.a. Bill Taylor
Bill is no longer with us. He died on 10 Dec 2012. We remember him always.
My TG Album
Last XaReg update
How about both?
I got this new 500MB hard drive with lots of room!
SCSI and everything...
-g-
My times have changed a lot over the years. My first PC compatable only had a 10MB hard drive and had to be partitioned in to two 5MB sections.
I sent a zip file to your personal email.
Soquili
a.k.a. Bill Taylor
Bill is no longer with us. He died on 10 Dec 2012. We remember him always.
My TG Album
Last XaReg update
Bookmarks