There was nothing set for default, I went into the Key Shortcuts bit and set it to H ... works fine afaics :-)
There was nothing set for default, I went into the Key Shortcuts bit and set it to H ... works fine afaics :-)
JOHN -XaReg (FB) XaReg (DB - ignore prompt to register)
Windows 10 [Anniversary] pro Intel Pentium CPU G630 @ 2.70Ghz RAM: 4 GB; 64-bit x64
Ah yes, good point. If you have made any changes to your hotkeys and saved them then you'll need to either use one of the Reset options in the hotkeyts dialog, as Handrawn says, or if you want to keep your hotkey setup, just use that dialog to assign whatever key you like to the "Toggle path handles on/off" command.
Phil
..... [Phil's post makes this redundant - please delete]
-------------------------------
Nothing lasts forever...
I re-set the short cuts and pressing 'h' does the job. I seem to get 1 control point displaying but that is no big deal.
Many thanks again. This is REALLY handy.
Huge Regards
Dave
What I would like to see in the future for the shapebuilder and the eraser tool is transparency settings on the info bar rather than having to back and forth to the transparency tool.
Square nibs
[SIGPIC][/SIGPIC]
My current Xara software: Designer Pro 365 12.6
Good Morning Sunshine.ca | Good Morning Sunshine Online(a weekly humorous publication created with XDP and exported as a web document) | Angelize Online resource shop | My Video Tutorials | My DropBox |
Autocorrect: It can be your worst enema.
-------------------------------
Nothing lasts forever...
Bookmarks