Originally Posted by
PhilM
I would do this:
* Draw a single hexagon (hold down Ctrl so that it's upright)
* Make sure magnetic snapping is turned on and "scale line widths" is turned off
* In the Selector tool use the right mouse button to drag a copy of the hexagon alongside it and click the left button to make a copy when the two hexagon's corners snap together
* Keep on doing that (you can just keep on dropping copies in the same drag) until you have a row that crosses the page
* Select the row
* Now use the right mouse button to drag copies of that row and snap them into place above and below the first row
That gives a perfectly aligned vector hexagon mesh.
Phil
Bookmarks