Quote Originally Posted by Acorn View Post
I agree.

The simplest way I know is to use the Erase tool at 100% round and set the diameter and scale the drawing.
Then touch on each vertex and drag out.

This splits the Line into segments where, with the Shape tool you pick the end of one segment and create a new node then drag the node onto the start of the next segment, rejoining the segments in this way until one Line again.

Very manual.

Acorn
TBH, I only half-understand that....
Either way one problem I have is the Eraser Tool diameter units always seem to be pixels not page units.

The other problem is that biting off a corner using either the Erase Tool or in fact using a circle of the desired diameter is that it tend to leave line segments behind at random/inconvenient places.

So what I end up doing is working with a square of the desired diameter and either adding it or cutting it off the shape in question. I then delete the unwanted line nodes and then dragging the resulting line by (roughly) it's middle to form some kind of fillet of roughly the desired radius.

Either way, yes VERY fiddly and manual.

J