Acorn - installed Xara software: Cloud+/Pro+ and most others back through time (to CC's Artworks). Contact for technical remediation/consultancy for your web designs.
When we provide assistance, your responses are valuable as they benefit the community. TG Nuggets you might like. Report faults: Xara Cloud+/Pro+/Magix Legacy; Xara KB & Chat
.
Gary W. Priester
gwpriester.com | eyetricks-3d-stereograms.com | eyeTricks on Facebook | eyeTricks on YouTube | eyeTricks on Instagram
Acorn - installed Xara software: Cloud+/Pro+ and most others back through time (to CC's Artworks). Contact for technical remediation/consultancy for your web designs.
When we provide assistance, your responses are valuable as they benefit the community. TG Nuggets you might like. Report faults: Xara Cloud+/Pro+/Magix Legacy; Xara KB & Chat
I just did. If you are talking about doing this without three cuts then I have done it. I did it without cuts.Note: in Xara you don't need to use any cuts whatsoever.
Can you describe how?
Gary W. Priester
gwpriester.com | eyetricks-3d-stereograms.com | eyeTricks on Facebook | eyeTricks on YouTube | eyeTricks on Instagram
One cut, 4 squares.
Or, you can Add Shapes with the two lines, then Combine Shapes > Slice Shapes (Ctrl 4) but you still have to Arrange > Break Shapes.
Gary W. Priester
gwpriester.com | eyetricks-3d-stereograms.com | eyeTricks on Facebook | eyeTricks on YouTube | eyeTricks on Instagram
Gary, I apologise for the confusion. My bad.
The Challenge was based around physical cuts. So I was expecting a pattern with three physical cuts.
My original 4-cut is barkingly wrong as it only took three!!
Your zero-cut Xara approach is as you described, apart from the resultant squares are the same size as the original so you need a cloning and halving step at the beginning.
Your one-cut Xara approach with a cookie cutter of two crossed lines is also good.
I plead stupidity, but other than the three-cut I incorrectly included, is there another 3-cut using scissors still out there?
In fact, could the three-cut for the long rectangles even be done as a 2-cut scissor action?
Most humbled,
Acorn
Acorn - installed Xara software: Cloud+/Pro+ and most others back through time (to CC's Artworks). Contact for technical remediation/consultancy for your web designs.
When we provide assistance, your responses are valuable as they benefit the community. TG Nuggets you might like. Report faults: Xara Cloud+/Pro+/Magix Legacy; Xara KB & Chat
I've exhausted my repertoire of moves.
Gary W. Priester
gwpriester.com | eyetricks-3d-stereograms.com | eyeTricks on Facebook | eyeTricks on YouTube | eyeTricks on Instagram
Acorn - installed Xara software: Cloud+/Pro+ and most others back through time (to CC's Artworks). Contact for technical remediation/consultancy for your web designs.
When we provide assistance, your responses are valuable as they benefit the community. TG Nuggets you might like. Report faults: Xara Cloud+/Pro+/Magix Legacy; Xara KB & Chat
Bookmarks