New Printer, Only prints half of whats on the page?

[EARTHPRINTS]

i tried all the settings from "ACORN" nothing seems to work.

work around...
export , import in to Corel (THAT SUCKS for me!)
Corel just plain sucks!

any other suggestions?

just so im clear its XARA not the printer? correct???

[Fred C]

Frank, you might try to export out of XPD11 as a pdf and print from there; perhaps as "commercial printing' for output type. I often send pdf's to a 36" wide Canon when XPD11 balks. Good luck!

[Egg Bramhill]

just so im clear its XARA not the printer? correct???

No I don't think so. Firstly you need to set up your page size in Xara. It's not a standard page size, so you'll need to set up a custom page size.

Then you need to set up the Printer Properties. I only have an A4 printer so it won't allow me to enter 20" x 10" but yours obviously will. You'll probably need to mess with the page bleed sizes too.

If you're going to be doing this a lot save your xar file:

Save Template /20x10 (or whatever name suits). You won't need to go through these steps each time then (I thinks )

[EARTHPRINTS]

yes i have many templates and i am very familiar with custom page sizes.




thank you again.

depending on what we are printing we pick a template.

24"x5" we can get 2 mugs.
24"x10" two mouse pads
etc.