I've attached a jpeg illustrating the problem with this particular drawing.
I've checked my page size with the size of the overall drawing, that matches up. And the drawing begins at 0, x and 0, y, lower left hand corner, up and to the right. So no problem there.
I checked to see if there were any hidden residuals by viewing the drawing in wireframe, but nothing shows up, and I even did a rectangular grab using the selection tool (arrow) a couple of times on the top and then the bottom of the drawing just to make sure there wasn't anything there that didn't show up on wireframe. Still nothing.
I've done a "select all" with all the layers open and editable. Still nothing.
I tried creating a new blank document of the same size and copying and pasting the drawing with the selection tool so I would only copy and paste the parts I wanted and with nothing being hidden into the new doc. Still the problem persists on export.
I've run out of ideas.
Please see attached export. (the large white gaps above and to the right of the export)
Bookmarks