Larry a.k.a wizard509
Never give up. You will never fail, but you may find a lot of ways that don't work.
A slow start this month.
As I did a couple of months ago, but in reverse, here is a drop cap for this month made with the scribble.
Bob.
** Detailed "Create A Spinning Logo Tutorial" is available in .pdf format for download at this link **
Outside of a dog, a book is a man's best friend. Inside of a dog, it's too dark to read. Groucho Marx.
while i have been attempting these scribble challenges, i always pass on posting my amateurish images. this one didn't turn out too bad and without others to compare it to at the moment....well, here goes....
Don't sell yourself short Mike. It looks great.
Larry a.k.a wizard509
Never give up. You will never fail, but you may find a lot of ways that don't work.
Good to see a couple of good posts. Here's mine, just the scribble with a pressure profile (propellor), cloned and a couple of nodes moved and then some infill of the spaces. Finally used to create a brush.
Egg
Minis Forum UM780XTX AMD Ryzen7 7840HS with AMD Radeon 780M Graphics + 32 GB Ram + MSI Optix Mag321 Curv monitor + 1Tb SSD + 232 GB SSD + 250 GB SSD portable drive + ISP = BT + Web Hosting = TSO Host
Thanks Egg. I was about to get Mr. Whathisname on you for pressure profiling the line then I thought so what, the line is still there. I remember doing one a long time ago and it turned out really cool but the line showed all by itself on the top so I deleted it. Wish I knew which one that was.
Larry a.k.a wizard509
Never give up. You will never fail, but you may find a lot of ways that don't work.
Thanks, Larry! I'd just finished this when Egg posted his excellent scribble. So if it's ok to use stroke shapes/pressure profiles, here's my offering.....The ducks are Pen Pressure, the water is Propeller and the reeds are Convex 2
Bookmarks