Xara3D to Photoshop Help

[handrawn]

yep I do believe I mentioned imageready - thanks for the rundown on the later versions

[mwenz]

Yes. I know you did. There's been a few versions since then...

[handrawn]

sure have ..but never need to upgrade myself.. actually, the way things are going I'll still be using xdpx next decade... <sigh> ...

[justicevallance]

got it thank you all for the help. Now I am running into another issue. I am trying to make another logo. this time used a video to try and learn to do it using inkscape. here is the video
https://www.youtube.com/watch?v=Qn8BcMQtILA

when I try to drag the image into Xara 3d I get the Message. this file does not contain any outlines.... but I did everything like the video suggested.
image is below

[Egg Bramhill]

Hi JV. If you're getting this message you're not converting the bitmap image to a vector shape and I very much doubt you'll be able to using any bitmap tracer, Inkscape, Xara or VectorMagic on this image. Xara 3D requires vector shapes which can then have bitmap textures applied. Converting your image to a vector shape, apart from hand tracing it is going to be all but impossible.

[handrawn]

actually that is just the sort of image that inkscape is very good at tracing into solid vector see attached which you can open in inkscape - I have deja vue this was all said 8 years ago

[using 'Brightness cutoff' at Threshold 0.610]

[justicevallance]

actually that is just the sort of image that inkscape is very good at tracing into solid vector see attached which you can open in inkscape - I have deja vue this was all said 8 years ago

[using 'Brightness cutoff' at Threshold 0.610]

Already knew it can be done and that it needs to be saved as a .EMF file. It shows in the video I posted what all needs to be done. Problem is I can not drop it into the Program with out that message popping up. so what did I do wrong?

Its obvious it can be done. is there a Program that works with Xara 3D so I can do this?