3d photo

[ec77]

ok thx u and this dont sound to easy. emma

[ec77]

oh and the text on the rounded square board i wasnt going to write on that emma

[simsmj]

Its true you may perhaps be trying to run before you can walk, but there is nothing to stop you at least trying the first couple of steps, like creating a spinning board with text on it. If you go so far and stop, that's fine, and you can always pick it up again later if you want.
The more you try things out the more comfortable you get with what you can do, and you are learning all the time.

And then the next steps will look much more straightforward.

The main thing is, just enjoy doing what you can do, and you will enjoy doing more and adding more to your skills.

Mike

[ec77]

im still trying but i can only get the board with text on it to spin half way and the text isnt to clear but im doing has text and not button is that right ? emma

[simsmj]

It's close enough, just reduce the line size to make the board and the text overlap more, and then select the text alone, and give it a thicker extrusion, so that it sits proud of the face of the board. With the Swing animation, you can change the extent of the swing by changing the angle. If you set 90 degrees, Swing moves from 0 to 90 in one direction, then all the way back to 0 and then to 90 in the other direction and back to 0 again. So the object will actually swing twice that angle in total.

Mike

[ec77]

got that bit done emma

[simsmj]

That's fine, you've adjusted the extrusion of the text. Did you change the animation to Rotate?.
If you adjust the line size to zero, both the text and the oval should be centred on each other.

Mike

[ec77]

hi the animation is moving in swing 1 and sorry what u mean size to zero ? emma