In the decimal only two?

[Angela Hellma]

When drawing on the letter size, I try draw rectangle 1.125 inch it only say 1.12 or 1.13 or 1.11. Why make it this way? Can I change make it 1.125 in three decimal. Sorry for English. Thank you for help.

[Angela Hellma]

Hello? Nobody here? I need make page fast! Thank you.

[Scotty]

the number of decimal places is governed by Windows 7 or whatever, you have to change it to 3 or four to get what you are after.
JimM

[Angela Hellma]

Thank you Scotty. Where I make this happen in Windows 7 or whatever? Can I make Xara tell Window 7 I want the 3 decimal?

[Angela Hellma]

Hello? Nobady here? I need support soon!

[Scotty]

Hi,
select my computer>control panel> Regional setting>currency and change decimal value in currency.
JimM

[Angela Hellma]

Currency? What currency? Not money!!! I need decimal point in Xara be 3? Can you make more detail please? I have no idea Jim what you talk about!

[jclements]

I am pretty sure the value of the third decimal place is "remembered", the display just rounds to nearest hundredth.

I suppose you could test it by drawing two squares, one at .125 x125 and the other at .13 x.13 and then scale both up by a large factor then measuring the sides of both squares. If I am correct, they shouldn't measure the same.

[The Alien]

I am pretty sure the value of the third decimal place is "remembered", the display just rounds to nearest hundredth.

This is correct. If you manually set the dimensions to 1.125 inch, the rectangle will be this size, but the display of the width/height in the box will be rounded to 1,13

[handrawn]

Currency? What currency? Not money!!! I need decimal point in Xara be 3? Can you make more detail please? I have no idea Jim what you talk about!

in windows XP the steps are as attached - I cannot say for windows 7 or other operating systems - this is what Jim was referring to, I think

once you have set this in windows - xara should use the same most of the time