Steam/Press Valet

**-=Drifter=-** · 30 August 2006, 07:16 PM

Alrighty then, the WATER CONTAINER APPARATUS has been plugged into the Westinghouse Steam/Press Valet and here it is...

**Egg Bramhill** · 30 August 2006, 07:21 PM

That must be one of the best drawn useless tools I've ever seen

**-=Drifter=-** · 30 August 2006, 07:24 PM

Hahahahaha... thanks Egg. Yes, I believe I used it ONCE - and then only to see what it did. It was a gift...
About all you can "iron" with it is a tie, and a skinny one at that!!!

**Intbel** · 30 August 2006, 07:50 PM

Posting this 'cos first I want to add my tuppence worth and say how well drawn are drifter's tools and also to 'bump' the thread to bring it to the fore.

Some great illustrations!

**parahandy** · 30 August 2006, 08:13 PM

Bob, well drawn as usual. You could use it for steaming open letters or maybe remove some of those irremovable labels.

**-=Drifter=-** · 30 August 2006, 08:30 PM

There is one thing about that drawing I couldn't get right... the wire/cord.

Why does the top edge look like that? It does in XaraX too.

The cord is simply a blend.

Thanks for the nice comments guys.

.....meanwhile, later....

okay, i just saved just the cord part and am uploading the .xar file in case someone wants to tell/show me why that edge is not smooth

**Ron Duke** · 31 August 2006, 04:48 PM

Bob,
Very nice job! Like the texture and the brass tag.
ron

**-=Drifter=-** · 31 August 2006, 05:12 PM

thanks for the nice comments, all of you

i tried what remi said on just the small wire .xar file and for the life of me i can't seem to get it to work