Printable View
good morning to all..
i imported a logo wmf format put a texture on it.everything was going well except when i put an animation (rotate). the logo warps or deforms as soon as starts spinning. texture is in jpg format.
any help would be highly appreciated..
thanks and more power...
Could you post an image of what is happening, or post the x3d file? That would help diagnose the problem.
Mike
thanks this will be my first time to send/attach an image. dunno if it will go through i usually have a bad internet access at the cafe..:oQuote:
Originally Posted by simsmj
magbobote,
I can't see any warp/deformation.
This is what I get.
Quote:
Originally Posted by Egg Bramhill
If you spin it around I see a deformation at the point
where the incuts are, probably because the texture want to
also go inside the incuts.
Made an avi out of it and the deformations don`t show.
I`ll see what a gif does.
yep the gif also doesn`t show the deformation.
It only happens in the program itself.
thanks and many thanks.
i did not actually view the image in other format, except in xara3d. you're right guys, no deformation in avi and gif format. why didn't i try that? ... :confused:
anyway thanks for the very quick response. more power.
i experienced this, i was following some of the threads and it was going as intructed but then the image seemed to concave in, whilst rotating
but once exported it was fine :o