Keith - Looks like you were spot on. No need to apologize. My and Acorn's remarks referred to the lack of feedback from Manny during the time we are flailing about trying to figure out what his request was.
Printable View
Keith - Looks like you were spot on. No need to apologize. My and Acorn's remarks referred to the lack of feedback from Manny during the time we are flailing about trying to figure out what his request was.
Acorn,
Look at Keith's final result and then look closely at the zoomed png file. It's the shape that is in the little badge shape just below the paperclip.
nicely done Keith
Yes, good one Keith.
I found a few minutes to try out my original thought which was to draw a rectangle, convert it to an editable shape and use the shape tool to bend the sides to points on a grid.
This works, but doesn't produce a particularly nice curve when added to the central rectangle. In the attached example I rotated the bent rectangle by 33 degrees.
Attachment 124623
My choice would go along with Gameprinters solution. Don't use a rectangle but a line with a large width, a butt cap, adjust as required, create a duplicate for reverse engineering if required in the future, and finally convert line to shape. Far simpler than bending a rectangle ;)