.
[This message was edited by Mike Bailey on July 09, 2003 at 20:57.]
Printable View
.
[This message was edited by Mike Bailey on July 09, 2003 at 20:57.]
.
[This message was edited by Mike Bailey on July 09, 2003 at 20:57.]
Getting a warm and fuzzy feeling all over Mike http://www.talkgraphics.com/images/smilies/biggrin.gif
Is this a ZBrush work?
Hi Randy, yes the fuzzmiester is a ZBrush trick.
IF you have the program and would like to give it a shot I can step ya through it ?
Fuzzpower http://www.talkgraphics.com/images/smilies/biggrin.gif
Cute http://www.talkgraphics.com/images/smilies/biggrin.gif It is good to see folks work'n with ZBrush... quite the tool set... way ta go Mike http://www.talkgraphics.com/images/smilies/smile.gif
Mike,
I am always interested in learning. Can you post some simple instructions and let me see if I can stumble through it.
Mike...
Who did you offend with your "graphic" pictures?
Curious,
Gare
Hey Gary, its nothing man. my mistake.
I was reading all the hoopla going on in the Xara forum, I guess it effected my mind.
http://www.talkgraphics.com/images/smilies/rolleyes.gif
Randy this should get you started.
Step 1. Open ZBrush, Use the default fast shader material and draw a large 3d sphere in the center of the canvas, any color you choose.
Step 2. In the layers palette, press BAKE, then create a new layer.
Step 3. Open the picker palette, at the top choose OTHER and CONTINUOUS COLOR
Step 4. Select the Fiber Brush, choose the flat color material and on the new empty layer begin drawing fibers all over the sphere.
Thats the basic set up for using the fiber brush.
To control the fibers size use the following adjustments, tool palette Fiber brush selected, modifiers.
To adjust the density: adjust the DRAW SIZE and FIBER DENSITY settings
Fiber length is controlled by the DRAW DEPTH setting
See the Attached images for details, when drawing you can clear the fiber layer at any time and start over, the sphere layer will not be effected.
When you are finished merge the fiber layer and sphere layers together. Then you can continue to the next phase.
Thanks Mike. I have saved this thread so I can try it out this weekend.