Printable View
I have put a ticket in for this one and it is being looked into but wondered if anyone else has the problem
editing a bitmap: attempt to use the mould tool to change perspective and get a crash every time.
works ok in the 32 bit version but not the 64bit
I can reproduce that - with perspective moulds - envelope moulds seem ok [but only done quick check]
yep, thank you for pointing that out
i too get complete crash, program disappears, no alerrt no warning
default perspective mould, move a node, using 64bit xdpx10
I've had a ticket in with this one... two or three replies... nothing can done so far. I'm told they can't replicate it on any of their machines so I'm glad I posted.
Would be nice to see it sorted though.
ok - for the record then: my machine is hp pavilion laptop intel core i3 processor, 8GB memory, 64bit windows 8.1, with intel HD graphics 4000
I could try it on my windows 7 aybe later
Ditto, crashes every time. Support may not be able to replicate it as they may be using a later version than the current download version.
I have 10.1.1.34966 Download version and have no problems at all. I used it the other day and just now tried it again no problems here.
My main machine is an Acer Pen and Touch 64bit with 12GB RAM. Windows 8.1
Also tried two others with the same result:Acer Netbook running windows 7.1 64 bit and an HP G56 Prosario 64bit with 4GB RAM
I've run the sequence with Windows performance monitor in view and it shows no strain on resources.
I''m using the latest download 10.1.1.34966 downloaded yesterday
darn forgot that - yes I'm using 10.1.1.34966 - [trial download if that makes any difference]
contributors should specify the version of xdpx10, 32 or 64 bit
i think it matters here
hey and it's usually me what be pedantic :)
64bit trial [sorta took that as read as the OP says no problem in 32bit - haven't got the 32bit trial]
10.1.1.34966 64 bit version.
Hi this issue has been logged for investigation. Its specific to the 64bit version and occurs when applying either a left or right perspective to a bitmap.
Thank you for bringing the problem to our attention
WOW! Designer was gone as soon as I try to use the perspective mould on a photo!
The file is not even in a tab when restarting the program!
I would label this as a 'bug' for sure...
No wonder I have no problem, I am using 32 bit version on a 64 bit windows 7 machine.
[QUOTE=occurs when applying either a left or right perspective to a bitmap.
Thank you for bringing the problem to our attention[/QUOTE]
It applies to all the perspective options
check - it happens with all five... but sometimes it happens immediately, othertimes need to drag a mould handle before it crashes
64-bit release version. Applied a default perspective envelope, edited the envelope, Xara stops working.