So I want to manipulate some text for a logo design I'm thinking of. Problem is, I don't know how to manipulate text in xara.
I need to manipulate the wor "2TurnTables" so that the two T's extend down and look like tonearms on turntables.
Printable View
So I want to manipulate some text for a logo design I'm thinking of. Problem is, I don't know how to manipulate text in xara.
I need to manipulate the wor "2TurnTables" so that the two T's extend down and look like tonearms on turntables.
I suppose you could use the mould tool on the T's - depends what you want..
mould examples:
Attachment 117802
or you could just draw them?
Type the text. Make a copy and convert it to shapes. Draw a tonearm. Size it, etc. the the width of the T's stem.
I did something similar to the 'P' in the design below.
Attachment 117803
Mike
Thanks gents. This is good information. I appreciate it.