Format for tumbler

Hello, I just want to ask on how do I automatically fit an image in this sample

http://www.theshaffers.org/graphics/...ry_tumbler.psd

I will be making a tumbler, thus I need an exact size for my picture

thanks :D

this is it, i want to put an image on it, how should i do it?

Just select the photo you want to place in the frame and there are many ways to do that. Open the photo you want to place in the frame. In the top menu go to select- Select All - then Edit, down to Copy - then back into Starbucks - make sure that you select the right layer and Paste it in. If you have move this photo layer do so -make sure its placed in the same layer below.

when I paste it, it just occupy the whole page. and I cant see the pattern for the starbucks.

also, is there a way to change and resized this pattern, my tumbler is way bigger and the bottom part is flat

this is similar to my tumbler shape

I hope more helps to come
thanks

Hi

when you have pasted in your image

drag the image layer so it is between the mask layer 'paste photo here' and the layer 'shape 1'

then hide the mask layer to see your image in place...

[note - I have had to reduce and zip the file in order to upload it within forum size limits]

If you want to make it bigger to for your glass it is and easy thing to do. Firstly you will need a template to fit your glass so you will need to get a piece of paper and paste it on to your glass. Now the next bit calls for a steady hand, take a pencil and hold it on the top rim of the glass and draw a horizontal line parallel to the top rim where you want the top of the label to be. Then do the same for the bottom of the label. The mark where you want the label to stop lengthwise and mark this on the bottom line. Measure the diameter of the top of the glass, measure the Dia. of the bottom and then divide the bottom by the top and that will give you a ratio between the two. With that ratio then measure the length of the bottom line and multiply the two that will give you a rough size without using technical drawing.

@ handrawn: thank you. I already done it.

only problem is, anway to resize the picture?
and
how can i adjust the size of the tumbler?