Extrude tool angles 1/2/3

[csehz]

Hi,

I am just playing with the Extrude tool angles to test how they behaves exactly, can you please advise about the Angle 1 and Angle 3 what is the difference between them?

According to the attached picture seems the same



Extrude_tool_angles.xar

thanks,

[gwpriester]

They do seem very similar and to be honest I am not sure what the difference is.

[csehz]

Mystic a little bit. Still trying the Angle 1 sure around the horizontal line turns, the Angle 2 around the vertical, so the Angle 3 should be logically through the crossed line but it works differently

[Rik]

Once you apply Angle 2, then you will see the difference between Angle 1 and Angle 3.

EDIT: The attached image hopefully shows what I mean?!

[gwpriester]

I learned something new today.

[csehz]

Ah so if Angle 2 > 0, then Angle 1 and Angle 3 are different, that is too high for my IQ Thanks I understand like this

[Rik]

Ah so if Angle 2 > 0, then Angle 1 and Angle 3 are different, that is too high for my IQ Thanks I understand like this

Not just > (greater than), it could also be < (less than).
In other words, if Angle 2 is anything other than zero, then Angle 1 and Angle 3 will be different.

[csehz]

Thanks just again the clarification