I'm in the proccess of making a Coke Can Stirling Engine which has a couple of CD's stuck together to make a fly wheel on one side and I was going to put a design on the disc to make it look good.

I see in "The Official Guide" there's a rotate tool and was wondering if I can make a circle that will rotate so I can see the outcome of different patterns before I actually print one out to attatch it to the CD. If I keep changing the design by sticking one design on top of another, eventually the engine will keel over to one side with all those covers stuck to it.

Doing it with Xara Extreme would save me a lot of covers and ink, if I could get the circle up and running. Not knowing enough to start I would apprciate a little help.


Thanks a lot.