New Patch=more errors

**Scotty** · 29 March 2006, 05:37 PM

Hi,
Any one else getting more error messages with new 0f patch?
When I type text then apply bevel I get error messages.
I didn't with last patch.
Jim

**Soquili** · 29 March 2006, 05:44 PM

Hi Jim,

No errors applying bevel to text using my laptop.

**RedWombat** · 29 March 2006, 05:53 PM

Hi Jim.

I had just rebuild my laptop and had not done the 0f update yet.

I tested what you mention on both 0e and 0f and did not get the error you mention.

**akubbeng** · 29 March 2006, 06:12 PM

Hello Jim,

no problems on my computer using the 0.f patch.

Regards, Albert

**Scotty** · 29 March 2006, 06:45 PM

Oh well maybe just my I will re-install and see what happens, I run various applications swithcing between so maybe some-thing left behind from the others.
Thanks for responses
Jim

**jclements** · 29 March 2006, 09:32 PM

Note sure if this is a new issue or not.

This morning I selected various objects (lines with arrowheads, closed curves with fills), some with drop shadows, copied them to the clipboard, did a Ctrl-Shift-V; however, the pasted objects were offset from their originals.

**Egg Bramhill** · 30 March 2006, 04:50 AM

John
I've noticed this offset throughout all Xara builds. It's to do with line widths, the heavier the line width the worse the offset.
Egg

**jclements** · 30 March 2006, 03:43 PM

It sure can cause extra work if you are not careful or aware, especially when creating graphics for progressive disclosures. I assume using duplicate and/or clone and then "move" in the layer gallery if needed, would have better results.