Solder (E4) and more...

[molucca]

Leaves with Flat Maps. Rich

[molucca]

A tin map. Rich

[John Rayner]

That looks pretty cool Rich.

[molucca]

Thanks John,

I bought a monopod and made a quick coupler. I went to the beach to photograph pelicans. Guess they weren't hungry, and didn't see any. I thought the coupler was too lose, but it did work. Rich

[John Rayner]

Neat shots Rich...

[molucca]

John,

A Flower Light. Rich

[John Rayner]

Now that one is cool... You should do an animation with all your lights.. Have em blowing in the wind while the snow is falling.

[molucca]

The quick disconnect. Rich

[John Rayner]

That is pretty cool Rich,

I will have to figure out something like that myself. Although I do have a quick disconnect built into my tripods. How stable is the connect when you have it "disconnected" from the tripod? Does the camera tip over?

[molucca]

John,

I installed brass plugs in each fitting, and tapped 1/4-20 threads. I made the delrin piece to prevent any tilting. It was somewhat wiggley. It needed to go slightly over center to lock. To get it just right, the cap screw was installed and acts against the hex in side the delrin spacer. I get the balls to lock with a little gap. Once the balls are locked, the spacer/fitting is turned about 1/8 turn to close the space. Nothing moves after that. It does rotate.

I went this morning to try it at the beach. Then disaster struk. Both dogs found dead seals and were rolling and rolling.

No pelicans again. Must have been my lucky day.

Rich