"Options..." window suggestions
Hi,
is there any chances to move these frequently used options:
from General tab - Angle constraint, Nudge size and Duplicate distance,
from Grid and Ruler tab - Grid and Ruler spacing and
from Mouse tab - Magnetic snap radii,
to status line, and leave or other, not so frequently used one, into "Options..." window.
I think there is no need "Options..." window to stay open for switching to use these options.
Re: "Options..." window suggestions
Of all of these settings, I think I personally have only ever touched the Grid & Ruler Spacing, and once it's set for a particular page size, I generally don't mess with it after that. But I suppose other people's workflow will be different than mine, and I can easily imagine that they might have need to access these on a frequent basis.
-- Ben
Re: "Options..." window suggestions
Perhaps a better solution might be to expose those options so you could make your own controlbar for them.
Re: "Options..." window suggestions
Yes, it would be nice. But it would be much better if they were located on the status line.
Re: "Options..." window suggestions
OK, we'll have to disagree on that one. I would prefer that the status line be left alone. The more stuff that's there, the harder it is to read quickly.
Re: "Options..." window suggestions
Yes, I’d agree with amoore there, Petar. We all use this software, so what is changed for you is changed for all of us. It is good to customize it to your own needs, but if I have to also have your customization I might not like it.
In my own case I use the same nudge and angle constraint etc. nearly all the time, and have never used the Grid and Ruler tab once in 15 years. I configure them in templates which never change. When I do change the settings for a particular file, it only takes a few seconds.