TG font collaboration #2 Roundhead

Just to let you all know I am working on my glyphs, but I'll be a day or two before I get them posted.

Fred the red letters in the template are only suggestions as I stated in the thread that contains the template.

Larry the square brackets should be the same have the same stem width as a capital letter and the same height. In the template file you will find a right hand parenthises as an example.

The attached .zip file contains a png of Gary's original image of the Roundhead sample sheet page. I have used an application that uses an s-spline algorithm to enlarge the image and sharpen the outlines. I hope this may help everyone.

Thanks Bill, I did note the example parenthesis example. It looks like it was on the base line and in my mind at least they should be somewhat longer then the capital height and descender, and centered which makes them not fit the template. So please someone tell me I'm wrong. I hope I'm making sense.

Bill here are the glyphs that I have been fixing. I hope these measure up! :)

OK here is the punctuation. I hope it is OK. If there is anything I missed let me know.

Attachment 89605

To complete this project we still need the upper and lower case glyphs to conform to the template. Anyone up to the job?

@Bill—

I think we'd all like some closure on this font, so we can use the bloody thing instead of trying to build it!

Send what you have to me via PM, and I will dedicate this afternoon to completing the rework so the characters have consistent stems and heights and ya-da-dah.

My Best,

Gary

Thanks Gary. Do you want the old upper and lower case files that have not been updated to comply with the template or just the files that Michele and Larry have updated?

How about both?

I got this new 500MB hard drive with lots of room! ;)

SCSI and everything...

-g-

My times have changed a lot over the years. My first PC compatable only had a 10MB hard drive and had to be partitioned in to two 5MB sections. :D

I sent a zip file to your personal email.