i tried all the settings from "ACORN" nothing seems to work.
work around...
export , import in to Corel (THAT SUCKS for me!)
Corel just plain sucks!
any other suggestions?
just so im clear its XARA not the printer? correct???
Printable View
i tried all the settings from "ACORN" nothing seems to work.
work around...
export , import in to Corel (THAT SUCKS for me!)
Corel just plain sucks!
any other suggestions?
just so im clear its XARA not the printer? correct???
Frank, you might try to export out of XPD11 as a pdf and print from there; perhaps as "commercial printing' for output type. I often send pdf's to a 36" wide Canon when XPD11 balks. Good luck!
No I don't think so. Firstly you need to set up your page size in Xara. It's not a standard page size, so you'll need to set up a custom page size.Quote:
just so im clear its XARA not the printer? correct???
Then you need to set up the Printer Properties. I only have an A4 printer so it won't allow me to enter 20" x 10" but yours obviously will. You'll probably need to mess with the page bleed sizes too.
If you're going to be doing this a lot save your xar file:
Save Template /20x10 (or whatever name suits). You won't need to go through these steps each time then (I thinks ;) )
yes i have many templates and i am very familiar with custom page sizes.
Attachment 112886
thank you again.
depending on what we are printing we pick a template.
24"x5" we can get 2 mugs.
24"x10" two mouse pads
etc.