You are probably correct Mike. It just goes to show you must be carefull regarding Join Shapes.
Printable View
You are probably correct Mike. It just goes to show you must be carefull regarding Join Shapes.
Thanks for the input. I think that I might have done a "Join" at one point. Executing a "Break," I see that I actually have three lines. I'll see what I can to to make them a single line ... then I suppose that they will properly close and create a shape.
I just looked at the file and mine was one line, and I found the two open points and it closed just fine.
Attachment 104290
Thanks Larry. That's much appreciated!
Glad I helped. After reading the other posts I wondered if I had messed up somewhere but at least it's closed now.