2 Attachment(s)
Extrude tool angles 1/2/3
Hi,
I am just playing with the Extrude tool angles to test how they behaves exactly, can you please advise about the Angle 1 and Angle 3 what is the difference between them?
According to the attached picture seems the same
Attachment 91632
Attachment 91633
thanks,
Re: Extrude tool angles 1/2/3
They do seem very similar and to be honest I am not sure what the difference is.
1 Attachment(s)
Re: Extrude tool angles 1/2/3
Mystic a little bit. Still trying the Angle 1 sure around the horizontal line turns, the Angle 2 around the vertical, so the Angle 3 should be logically through the crossed line but it works differently
Attachment 91651
1 Attachment(s)
Re: Extrude tool angles 1/2/3
Once you apply Angle 2, then you will see the difference between Angle 1 and Angle 3.
EDIT: The attached image hopefully shows what I mean?!
Re: Extrude tool angles 1/2/3
I learned something new today. :)
Re: Extrude tool angles 1/2/3
Ah so if Angle 2 > 0, then Angle 1 and Angle 3 are different, that is too high for my IQ :D Thanks I understand like this
Re: Extrude tool angles 1/2/3
Quote:
Originally Posted by
csehz
Ah so if Angle 2 > 0, then Angle 1 and Angle 3 are different, that is too high for my IQ :D Thanks I understand like this
Not just > (greater than), it could also be < (less than).
In other words, if Angle 2 is anything other than zero, then Angle 1 and Angle 3 will be different.
Re: Extrude tool angles 1/2/3
Thanks just again the clarification