X2. Can't set Range in edge seeker
I thought I was supposed to be able to, and in PSP9 I could, but when I use the edge seeker, the Range section is greyed out.
Help says it should be available.
Am I using a wrong setting? ANy suggestions about what could be causing this?
Thanks for any help
Nick
1 Attachment(s)
Re: X2. Can't set Range in edge seeker
It works fine for me, Nick, but I find the Range section is greyed out when selecting Freehand, Point to Point and Smart Edge...how odd!
The same results with PSP X, so I imagine that's how the selection freehand tool is set up. But I'm afraid it doesn't answer your question, though.
Saludos,
Bob.
Re: X2. Can't set Range in edge seeker
My memory betrayed me. In PSP 9 the wording is "You can only use the Range in Edge Seeker". It's worded a bit differently in X2. Also I was using the wrong terminology. I was using Smart Edge (the rectangle) not Edge Seeker.
So I was rather muxed ip.
Nick
Re: X2. Can't set Range in edge seeker
Glad you got that sorted, Nick. Solved the mystery of the greyed out boxes in the other Selection Tool selections, too.
Saludos,
Bob.
Re: X2. Can't set Range in edge seeker
Hehe. Well I hope it helps _someone_. I feel a bit daft. :o
Nick
Re: X2. Can't set Range in edge seeker
Nick, the little (:o) icon is there for a reason! You'd be surprised how often it's used. We all do it, so my advice is to pay it no mind. :)
Saludos,
Bob.
Re: X2. Can't set Range in edge seeker
Hah! So I should be :o about using the :o? <G>
Nick